Hubsoft integration with Furukawa

About Furukawa

Furukawa Electric is a group that manufactures optical fiber and electrical cables. In Latin America, its fiber and connectivity operation became Lightera, bringing together Furukawa Electric's fiber and cable division, Furukawa Electric LatAm, and OFS. The OLTs integrated with Hubsoft are from the LD30xx and G2500 lines.

What the integration does

The integration connects Hubsoft to the Furukawa OLT over SSH. Once the OLT is registered, the team can use Hubsoft to:

• View the ONUs connected and pending authorization on each PON port.
• Authorize the ONU linked to the customer and service, using the selected CPE profile. Provisioning runs immediately afterward, with no additional action.
• Unauthorize and deprovision using the commands from the same profile.
• Authorize and provision in bulk, one PON at a time, for ONUs already linked to services by serial number.
• Enter the Wi-Fi name and password, including for the 5 GHz network, during authorization when the CPE profile includes Wi-Fi commands.
• Run custom commands after provisioning, such as adjusting Wi-Fi or activating VoIP.
• Receive an alert when the ONU signal exceeds the threshold on ports with monitoring enabled.
• Log the commands sent to check the OLT response when something fails.

Integrated models:

• LD3008 (SSH, port 22)
• LD3016 (SSH, port 22)
• LD3032 (SSH, port 22)
• G2500 (SSH, port 22)

What you need

• A Furukawa OLT in one of the models above, with an access IP address.
• The username, password, and access port for the OLT used by Hubsoft.
• The OLT's POP registered under Network > Points of Presence.
• CPE profiles with authorization, provisioning, deprovisioning, and unauthorization commands under Configuration > Network > CPE Profiles. The Hubsoft team has reference profiles for Furukawa (bridge).

How to enable it

1. Under Network > Connection Equipment, click Add and enter the name, IP address, Furukawa as the manufacturer, the model, and the POP.
2. Enter the username, password, and access port: SSH, port 22.
3. Under Actions > View, enable editing and register the PON ports on the Interfaces tab, individually or in bulk, with the chassis, slot, PON, starting VLAN, VLAN increment, default CPE profile, and the concentrator that authenticates customers.
4. To test, open Actions > View Connected Customers and check the Layer 2 and Pending Layer 2 tabs.
5. Authorize the first ONU using the menu next to it, entering the customer, service, and CPE profile.

The step-by-step guide with screenshots is available in the Hubsoft wiki: OLT and port registration, ONU authorization and provisioning and integrated OLT list.

Limitations

• Bulk authorization and provisioning work with one PON at a time. If the PON has ONUs in bridge and router mode, process one type at a time.
• When registering ports in bulk, register no more than 4 slots at a time.
• When switching PONs, unauthorize the ONUs from the old PON directly on the OLT. In Hubsoft, unauthorization also removes the link between the customer and the ONU.

Frequently asked questions

My Furukawa model isn't on the list. What now?

Contact the Hubsoft Infra Support team. They will assess the feasibility of integrating the model.

Does the technician need the OLT password?

No. The username and password are stored in the equipment record. Operators can view and authorize ONUs from the Hubsoft screen without the OLT credentials.

Can I authorize multiple ONUs at once?

Yes, one PON at a time, under Actions > View Connected Customers. The ONUs must be linked to the customers' services, with the serial number entered on the service's Authentication tab. After bulk authorization, bulk provisioning applies the CPE profile and VLAN.

Reviewed on 10/10/2026.