Hubsoft integration with Overtek

Hubsoft, an ERP for internet service providers (ISPs), integrates with Overtek to authorize, provision, and deauthorize ONUs on its OLTs. Technicians release a subscriber's ONU from the Hubsoft screen without needing OLT credentials.

Overtek sells equipment for fiber, wireless, and cable internet service providers (ISPs). With Hubsoft, the Overtek 8110T OLT is added as connection equipment to authorize and provision ONUs.

Request a Demo Partner website

About Overtek

Overtek is a store specializing in products for cable, wireless, and fiber-optic internet service providers (ISPs). Its catalog covers FTTx optical networks, GEPON and GPON equipment, structured cabling, and wireless networks.

What the integration does

With the Overtek OLT registered as connection equipment, the team can use Hubsoft to:

View connected ONUs and those pending authorization on each PON port.
Authorize the ONU linked to the customer and service, using the selected CPE profile. Provisioning runs right afterward, with no further action.
Deauthorize and deprovision using the commands from the same profile.
Authorize and provision in bulk, one PON at a time, for ONUs already linked to services by serial number.
Enter the Wi-Fi name and password, including for the 5 GHz network, during authorization when the CPE profile includes Wi-Fi commands.
Run custom commands after provisioning, such as adjusting Wi-Fi or activating VoIP.
Get alerts when the ONU signal exceeds the limit on ports with monitoring enabled.
Record sent commands to check the OLT response when something fails.

Integrated model:

8110T

What you need

Overtek OLT of the model above, with an access IP address.
Username, password, and access port for Hubsoft to connect to the OLT.
The OLT's POP registered under Network > Points of Presence.
CPE profiles with authorization, provisioning, deprovisioning, and deauthorization commands under Configuration > Network > CPE Profiles.

How to activate

Under Network > Connection Equipment, click Add and enter the name, IP address, Overtek as the manufacturer, model, and POP.
Enter the username, password, and OLT access port. Confirm the protocol and port with Hubsoft Support.
Under Actions > View, enable editing and add the PON ports in the Interfaces tab, individually or in bulk, with chassis, slot, PON, starting VLAN, VLAN increment, default CPE profile, and the concentrator that authenticates customers.
To test, open Actions > View Connected Customers and check the Layer 2 and Pending Layer 2 tabs.
Authorize the first ONU using the menu next to it, entering the customer, service, and CPE profile.

The step-by-step guide with screenshots is available in the Hubsoft wiki: OLT and port registration, ONU authorization and provisioning and integrated OLT list.

Limitations

Bulk authorization and provisioning work with one PON at a time. If a PON has ONUs in bridge and router mode, process one type at a time.
When registering ports in bulk, register a maximum of 4 slots at a time.
When changing PONs, deauthorize the ONUs from the old PON directly on the OLT. In Hubsoft, deauthorization also removes the customer's link to the ONU.

Frequently asked questions

My Overtek model isn't on the list. What now?

Contact Hubsoft's Infrastructure Support team. They will assess whether the model can be integrated.

Does the technician need the OLT password?

No. The username and password are stored in the equipment record. Operators can view and authorize ONUs from the Hubsoft screen without the OLT credentials.

Can I authorize multiple ONUs at once?

Yes, one PON at a time, under Actions > View Connected Customers. The ONUs must be linked to customer services, with the serial number entered in the service's Authentication tab. After bulk authorization, bulk provisioning applies the CPE profile and VLAN.

Revised on 10/10/2026.